We are trying to apply QoS/traffic shapping on out 6500 with FlexWan. The problem occurs when trying to apply the "frame-relay traffic-shaping" to the serial interface the IOS will not take the command. All of the documentation states that this must be done. Any suggestions?
Partial config below:
class-map match-all voip-control
match access-group 101
class-map match-any voip-rtp
match ip rtp 16383 16383
match access-group 100
!
!
policy-map QOS-Policy-VOIP
class voip-rtp
priority 120
class voip-control
bandwidth 8
class class-default
fair-queue
!
map-class frame-relay QOS-448
no frame-relay adaptive-shaping
frame-relay cir 448000
frame-relay bc 4480
frame-relay be 0
frame-relay mincir 384000
service-policy output QoS-Policy-VoIP
frame-relay fragment 320
!
map-class frame-relay QOS-576
no frame-relay adaptive-shaping
frame-relay cir 576000
frame-relay bc 5760
frame-relay be 0
frame-relay mincir 320000
service-policy output QoS-Policy-VoIP
frame-relay fragment 320
!
map-class frame-relay QOS-640
no frame-relay adaptive-shaping
frame-relay cir 640000
frame-relay bc 6400
frame-relay be 0
frame-relay mincir 576000
service-policy output QoS-Policy-VoIP
frame-relay fragment 320
!
access-list 100 permit ip any any precedence critical
access-list 100 permit ip any any dscp ef
access-list 101 permit ip any any precedence flash
access-list 101 permit ip any any dscp af31
!
interface Serial8/0/3:0
frame-relay traffic-shaping
!
interface Serial8/0/3:0.322 point-to-point
frame-relay interface-dlci 322
class QOS-640
!
interface Serial8/0/3:0.406 point-to-point
frame-relay interface-dlci 406
class QOS-448
!
interface Serial8/0/3:0.408 point-to-point
frame-relay interface-dlci 408
class QOS-576
!
!
