07-29-2006 01:55 AM - edited 03-03-2019 01:29 PM
Hi,
My 7120 router stuck in romon mode.
When i give reset
It gives the following error
*** TLB (Load/Fetch) Exception ***
Access address = 0x0
PC = 0x0, Cause = 0x8, Status Reg = 0x3040d003
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issued
***
it keeps on going
after i give crtl + break only it return to romon mode
after that if give boot flash
after decompressing it gives
No fault history 0x0. Need 11.1 (2) or higher ROM
Free space check for bootflash:crashinfo_20060729-012548 failed (-1/9279)
and
Nested r4k_return_to_monitor call (2 times)
and return back to romon
Can any one help me regarding this
plase
Thanks
Ranga
07-29-2006 02:12 AM
Hi ,
when i swicth off the power and power on
it says the same thing
*** TLB (Load/Fetch) Exception ***
Access address = 0x0
PC = 0x0, Cause = 0x8, Status Reg = 0x3040d003
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issued
***
Thanks
Ranga
07-30-2006 08:15 PM
According to the message, I believe the bootflash may be corrupted.
Found a doc., hope this helps.
http://www.cisco.com/en/US/products/hw/routers/ps359/products_tech_note09186a00800a750e.shtml
http://www.cisco.com/en/US/products/hw/vpndevc/ps333/products_tech_note09186a00800c8978.shtml
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: