08-03-2011 01:36 PM - edited 03-04-2019 01:10 PM
Hello,
We installed a 7200 with a NPE-G1 at a new site and the QOS policy-map is not reporting the correct offered rate. Below is the interface 5 minute rate which is correct and the policy map rate. I am afraid this might through off the measurement on our priority queue policing. It just doesnt add up. Any ideas?
I checked bug tracker and another IOS version...same issue.
disk2:c7200-advipservicesk9-mz.151-4.M.bin"
GigabitEthernet0/1 is up, line protocol is up
5 minute input rate 4000 bits/sec, 7 packets/sec
5 minute output rate 2000 bits/sec, 2 packets/sec
GigabitEthernet0/2 is up, line protocol is up
5 minute input rate 1000 bits/sec, 2 packets/sec
5 minute output rate 2000 bits/sec, 4 packets/sec
--------------------------
GigabitEthernet0/1
Service-policy output: PMAP_INTERFACE_GIG0/1
queue stats for all priority classes:
queue limit 64 packets
(queue depth/total drops/no-buffer drops) 0/0/0
(pkts output/bytes output) 36480/5117423
Class-map: CMAP_MATCH_MPLS_EXP_5 (match-any)
36480 packets, 880910870 bytes
5 minute offered rate 37000 bps, drop rate 0 bps
Match: mpls experimental topmost 5
36480 packets, 880910870 bytes
5 minute rate 37000 bps
Priority: 50000 kbps, burst bytes 1250000, b/w exceed drops: 0
Class-map: class-default (match-any)
182125 packets, 149223669 bytes
5 minute offered rate 75000 bps, drop rate 0 bps
Match: any
queue limit 64 packets
(queue depth/total drops/no-buffer drops) 0/0/0
(pkts output/bytes output) 182119/20801795
------------------------------------------
08-04-2011 07:45 AM
Found it.
CSCth99107
If anyone from TAC is watching it is affected in my version above. I searched for any 15.1
08-04-2011 10:20 AM
Actually, this bug is closer to your issue:
In any case, I highly recommend opening a support ticket.
Regards,
Edison
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide