7600 Log Message

[Ahmed Erfan Mehdi]

Dear Experts,

would you please clarify this log message:

*Oct 23 06:20:07 UTC: %FPD_MGMT-3-INCOMP_IMG_VER: Incompatible ROMMON (FPD ID=5) image version detected for 7600-SIP-200 card in slot  Detected version = 1.3, minimum required version = 1.4. Current HW version = 2.303.

==== ====================== ====== =============================================

                             H/W   Field Programmable   Current   Min. Required

Slot Card Type               Ver.  Device: "ID-Name"    Version      Version

==== ====================== ====== ================== =========== ==============

   1 7600-SIP-200            2.303 1-I/O FPGA             1.3         1.3     

                                   2-EOS FPGA             1.220       1.220   

                                   3-PEGASUS TX FPGA      1.133       1.133   

                                   4-PEGASUS RX FPGA      1.6         1.6     

                                   5-ROMMON               1.4         1.4     

---- ---------------------- ------ ------------------ ----------- --------------

1/0 SPA-2XOC3-POS           1.0   1-I/O FPGA             3.4         3.4     

---- ---------------------- ------ ------------------ ----------- --------------

1/1 SPA-8XCHT1/E1           1.5   1-ROMMON               2.12        2.12    

                                   2-I/O FPGA             2.8         2.8     

==== ====================== ====== =============================================

just today i did IOS upgrade ( 12.2(33) SRD 8 ) and i got above log.

Please advice.

Regards,

Ahmed

[Ivan Shirshin]

Hi,

This message typically means that you need to upgrade FPD software on the SIP module. Guidelines here:

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/76fpd.html#wp1063108

The easiest way is to just place fpd package file on flash disk before upgrading. Since you already did, you can place the file and reload router again with SRD8.

File you can find here (double check if the supervisor selection is correct):

http://www.cisco.com/cisco/software/release.html?mdfid=282201754&flowid=937&softwareid=280805682&release=15.2.4S1&relind=AVAILABLE&rellifecycle=ED&reltype=latest

I see, though, that current version should be 1.3 while the output you posted shows 1.4 already. Did you do the upgrade since seeing the message?

==== ====================== ====== =============================================

                             H/W   Field Programmable   Current   Min. Required

Slot Card Type               Ver.  Device: "ID-Name"    Version      Version

==== ====================== ====== ================== =========== ==============

   1 7600-SIP-200            2.303 1-I/O FPGA             1.3         1.3    

                                   2-EOS FPGA             1.220       1.220  

                                   3-PEGASUS TX FPGA      1.133       1.133  

                                   4-PEGASUS RX FPGA      1.6         1.6    

                                   5-ROMMON               1.4         1.4    

Kind Regards,
Ivan Shirshin

**Please grade this post if you find it useful.