Routing

hola  a todos. necesito tu ayuda:   estoy por configurar una Red pero estoy a cero: Tengo 2 Enlaces  de Distintos Proveedores,  tengo 2 Router RV042,...  y ya me  mandaran 2 Switches Catalyst 2960..  quien me puede indicar como los puedo configurar...

I am trying to run the following commands on a 2801 router, but the commands are missing:mls qos mls qos map cos-dscp 0 8 16 40 32 46 48 56The only QoS command i have in global config is (no MLS qos) :REMOTE-ROUTER1(config)#qos ?  restore-show-output...

Hello,I am very new in Cisco and this is a first time that I've received task to configure it. This is going to be my backup router in case one of 2 existing Cisco 857 routers fails. I will keep new router off-line but first I would like to configure...

Hi All,Wonder if one of you might be able to clear up a question. I'm looking at an existing config with the following detail in it:class-map match-any Gold-Outboundmatch ip dscp ef!!policy-map ABC-GOLDclass Gold-Outbound    priority 5012class class-...

Dear All ,               Can someone please provide me the solution as per my required with the best devices little confuse in selection,below is the details1: have 2 Wan ISP link want a Fail Over on it ,if any 1 of Wan link go down another link auto...

Hi,Need some suggestions in getting my 7200 back up and running.  Long story short I formatted my 7200 CF in another platform as I needed to lab something rather quickly and totally forget my 7200 boots from this.  Problem is the 7200 will no longer ...

Hello everyone,To start with I would to thank and appreciate this forum for the help and knowledge I have acquired through this as a beginner in this wonderfull technology.My next question is this: On my home Lab I want to setup my mail (Exchange) se...

Hi All,Just wondering if anyone knows if Cisco does their own burn-in of completed ASR1004 and ASR1006 routers before they are shipped.Thanks!Mark                 

Hi We are getting this bizzar error messages accross the board 30 plus routers (76XX) and message time stamp is the same for all the routers meaning we get this error message around 17:55 in the evening. Cant seems to find any answer please help. FYI...

Hello,I'm designing the implementation of PfR in my network. I would like to know if my border routers can support EIGRP Parent Routes.(I've read in the documentation that there is a CSCsk39768 - PfR-EIGRP integration for future releases. Where can i...

Hello All,10.X.X.X subnet need to be natted to 192.168.X.xHere customer LAN is 10.X.X.x  and 192.168.X.X is the place where client server is located.We have to NAT 10.x.x.x  to 192.168.x.x as 10.x.x.x subnet is not permitted at server end. There is o...

I have IPsec setup between two networks 172.18.1.0 (remote office) and 172.16.0.0 (corporate office) accross the public internet. Except for one minor issue everything works well. If I telnet to the remote office router and then ping an address on 17...