Hello Dears,
Does anyone have an idea, if the 7600-SIP-200 supported in VSS mode or not ?
I have configured to Cisco Catalyst 6513 as VSS, both of them have the 7600-SIP-200 module, before converting them to VSS I was able to work with the 7600-SIP-200 module, but after I did convert them to VSS, both modules didn't work.
here is the show module output, after VSS conversion:
VSS1#show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 0 4-subslot SPA Interface Processor-200 7600-SIP-200 JAE14500GMT
7 5 Supervisor Engine 720 10GE (Active) VS-S720-10G SAL15024PV9
10 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE SAL15024Q5R
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 e05f.b95d.e900 to e05f.b95d.e93f 2.303 Unknown Unknown PwrDown
7 c47d.4ffe.8920 to c47d.4ffe.8927 4.0 8.5(4) 12.2(33)SXH8 Ok
10 1cdf.0f1a.e5b0 to 1cdf.0f1a.e5b3 3.2 12.2(14r)S5 12.2(33)SXH8 Ok
Thanks
Ibra,
