ADSL Configuration Cisco C1113-8p

[gtomasicchio]

I don't get ppp

I don't see the IPs on the dialers

the atm 0/2/0 is raised

controller VDSL 0/2/0
operating mode adsl2+
firmware phy filename bootflash:c1100_gfast_phy_fw_A45q_B45q.pkg
modem l

interface ATM0/2/0
description ToH:xxxxxxxxxxxx+P:ae14+N:
no ip address
load-interval 30
atm oversubscribe factor 2
no atm ilmi-keepalive
no snmp trap link-status
pvc 8/35
vbr-nrt 637 637
oam-pvc 0
oam retry 3 3 5
encapsulation aal5snap
service-policy out PARENT
pppoe-client dial-pool-number 3
pppoe-client dial-pool-number 1

[marce1000]

       - FYI : https://community.cisco.com/t5/networking-knowledge-base/troubleshooting-for-pppoe-connection-failure-part-1/ta-p/3147204

  M.

[gtomasicchio]

hi, the problem is that I don't know if that type of router is suitable for ADSL. I usually use the Cisco 887 and 897 and never had any problems but the Cisco C1113 should work too.
Physical ADSL is on but I don't see the IPs on the dialers.
The dialer configuration part is there and has been verified.
I would like to know if there is anything else to put on the vdsl 0/2/0 controller or atm0/2/0 interface.
Thank you

[marce1000]

  - Ref : https://www.cisco.com/c/en/us/products/collateral/routers/1000-series-integrated-services-routers-isr/datasheet-c78-739512.html
   >.... (Table 24)   = DSL should be possible

C1113-8P(M)W*	1	Yes	No	Yes	8
C1113-8P(M)LTEEA/LA	1	Yes	Yes	No	8
C1113-8PLTEEA/LAW*	1	Yes	Yes	Yes	8

[gtomasicchio]

fixed as the logical interface was missing.

ATM0/2/0 interface
description ToH:xxxxxxxxxxxx+P:ae14+N:
no IP address
load range 30
excessive ATM subscription factor 2
no ilmi-keepalive ATMs
no snmp trap link status
!
ATM0/2/0.1 point-to-point interface
PVC8/35
vbr-nrt 637 637
oam-pvc 0
oam try again 3 3 5
aal5snap encapsulation
pppoe-client dial-pool-number 3
pppoe-client dial-pool-number 1

[marce1000]

 - Checkout : https://www.cisco.com/c/en/us/td/docs/routers/access/1100/software/configuration/xe-16-7/cisco_1100_series_swcfg_xe_16_7_x/cisco_1100_series_swcfg_chapter_01001.html

  M.

[gtomasicchio]

I had seen that configuration but it had to be adapted to the type of configuration we had.