I was going to reset the router config and instead did it while in the ap#. So when I try to get to it, it starts off in ap> instead of ap# when it try doing ap> en it always asks for a password 3 times and it is not the default cisco password. Anyway I can fix this or do I need to reset the router?
Please rate and mark as an accepted solution if you have found any of the information provided useful. This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
have you tried no password (just enter at the prompt) ? Depending on your IOS version, you might be able to get HTTP access (type the LAN IP address of your router into a web browser)...
Please rate and mark as an accepted solution if you have found any of the information provided useful. This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
