ASA netflow and small TCP sessions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-10-2015 08:17 AM - edited 03-05-2019 12:59 AM
Dear Sirs.
I use netflow on the ASA5515-X and netflow collector (ManageEngine) for collect traffic information, but I do not see very small traffic.
I use capture on the ASA and see this traffic, but netflow do not send to collector about it (I viewed netflow packet in WireShark).
What can I do?
Thank!
Helping seriously ill children, all together. All information about this, is posted on my blog
- Labels:
-
Routing Protocols
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-17-2015 01:54 AM
Make sure your ASA is configured as below:
https://supportforums.cisco.com/document/30476/configuring-netflow-asa-asdm
And make sure you set the template timeout to 1 minute instead of the suggested 30.
Regards,
Don Jacob
http://www.solarwinds.com/netflow-traffic-analyzer.aspx
PS: Dont forget to rate and close helpful answers.
