cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
5
Helpful
1
Replies

ASR 1K+L2TP NOT WORKING FOR VLAN 1

vinayjaiswal
Level 3
Level 3

Hi Team ,

 

We are trying to establish L2TP tunnel between two ASRs.

 

Topology is below :

 

ASR connected to ASR on other end which is connected to an unmanaged switch.

 

When configuring the tunnel between two sub interfaces , the tunnel is coming up . However we are not able to route traffic. We suspect the issue that unmanaged switch  on the other end is causing the issue as it can only forward traffic for 1 VLAN but we can't put sub interface in any vlan.

 

Can you suggest if we need to check anything other than changing the unmanaged switch ?

1 Reply 1

Kevin Groves
Level 1
Level 1

I would rule out the unmanaged switch first. If it works without then you know what device to tackle.


** Click (star) if you felt this was helpful.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card