Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
5Ghz Clients are connecting to faraway AP even if they sit under the same model another 2700i AP. Both AP's are autonomous.
Attached configuration files from both AP's. Also need the debug command which will work on autonomous AP.
We observed one link between TNCHNPERNER03 to KKBNGBTPNCR02 has flapped at the same time observed route flapped between source to destination. We observed destination Ip is taking path via Po12 but observed less traffic , for now we have shut the Po1...
Hi Paul, Here issue is not related to Link flapping we had concern that traffic is showing routes from PO12 but it doesn’t have high amount of traffic & when Po12 made shut & no-shut issue got resolved.
Hello Georg, have you configured 'channel-group min-link' under the port channel? No showrun Po12 shared below. MODEL-ASR903 TNCHNPERNER03#show run int Po12Building configuration... Current configuration : 513 bytes!interface Port-channel12descripti...
