ASR 903 BDI interface not pinging from Cisco 3560CG
There is an indirect connectivity between ASR 903 router and Cisco 3560CG router for which the configured to be in same IP segment. The two devices are not pinging from each other, but able to ping other devices from both which are in the same LAN segment.
service instance 600 ethernet description COLLECTOR encapsulation dot1q 600 rewrite ingress tag pop 1 symmetric bridge-domain 600
interface BDI600 description COLLECTOR ip address 100.66.44.9 255.255.254.0 no ip redirects no ip unreachables
CA93-01#ping 100.66.44.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 100.66.44.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms MH-MUM-GFD-B1-ST-MCM-MRT-CA93-01#ping 100.66.44.20 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 100.66.44.20, timeout is 2 seconds: ..... Success rate is 0 percent (0/5)
CA93-01#sh ip arp | i 100.66.44.20 Internet 100.66.44.20 114 f078.16bd.6741 ARPA BDI600
3560CG#sh run interface vl600 Building configuration...
Current configuration : 110 bytes ! interface Vlan600 ip address 100.66.44.20 255.255.254.0
Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 100.66.44.9, timeout is 2 seconds: ..... Success rate is 0 percent (0/5)
3560CG#sh ip arp | i 100.66.44.9 Internet 100.66.44.9 0 188b.454c.5cbf ARPA Vlan600
One thing is in arp table of the switch, arp for that particular router is continuously flushing and always is "0". On the other end, in router there is
Inviting all network professionals in operations! We'd like to understand what would be valuable for you in a mobile application. Your response will help Cisco improve a product feature that could benefit you. Thanks!
Click here to take the sur...
Cisco’s software-defined wide area network (SD-WAN) solution allows user to quickly and seamlessly establish an overlay fabric to connect an enterprise’s data centers, branch and campus locations, as well as colocation facilities in order to imp...
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...