09-06-2012 12:47 AM - edited 03-04-2019 05:29 PM
Hello.
I plan to connect the two ASA 5540 to the ASR 1001. ASA cluster operates in active\standby mode.
I'm correctly understand the documentation that such a scheme would work right when failover will occur?
ASR IOS XE Version: 03.06.01.S
interface GigabitEthernet0/0/1
description asa1
no ip address
negotiation auto
service instance 1 ethernet
encapsulation untagged
bridge-domain 1
!
!
interface GigabitEthernet0/0/2
description asa2
no ip address
negotiation auto
service instance 1 ethernet
encapsulation untagged
bridge-domain 1
!
!
interface BDI1
ip address x.x.x.1 y.y.y.y
!
ip route 10.0.0.0 255.0.0.0 x.x.x.2 # as example route will work correct.
ASA interface has IP address x.x.x.2 standby x.x.x.3
Solved! Go to Solution.
09-06-2012 01:11 AM
Hello Andrej,
it should work as the BDI feature is like IRB in IOS routers, but in this network setup the ASR 1001 is a single point of failure.
Hope to help
Giuseppe
09-06-2012 01:11 AM
Hello Andrej,
it should work as the BDI feature is like IRB in IOS routers, but in this network setup the ASR 1001 is a single point of failure.
Hope to help
Giuseppe
09-08-2012 07:09 AM
Hello Giuseppe,
Thank you for confirmation of possibility. This was not complete design, in real there no point of failure actually.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide