ATM configuration

[robert.v.russojr]

I am trying to configure a Cisco 3845 with a NM-1A-T3 ATM card to pass traffic through to a Marconi TNX-1100. Cells are sent but no data. Does anyone have any suggestions on what is wrong?

Thanks

[a-vazquez]

In these type of cards mostly hardware failure seems to be an issue.Try replacing the card.Before doing that debug atm bundle errors,debug atm bundle events are the commands used to troubleshoot.Refer the following URL for more info

http://www.cisco.com/en/US/tech/tk39/tk48/technologies_configuration_example09186a0080094e84.shtml

[mheusinger]

Hi, can you post the relevant config?

Are there any interface error counters increasing? Could be a payload scrambling issue ... make sure the T3 line settings absolutely match between the Cisco and the Marconi.

Regards, Martin