Hi,
I am facing some problem with Auto-RP config . Actually I am not getting IP announcements at receiver side even though source is sending periodic announcements. Bellow are the logs:
At PE( near to source):
ip pim vrf Multi_1 autorp listener
At CE ( Source ):
no ip pim vrf Multi_1 dm-fallback
ip pim vrf Multi_1 autorp listener
ip pim vrf Multi_1 send-rp-announce 212.31.219.227 scope 5 group-list 56 interval 5
Logs at Source CE :
CE2#
*Oct 4 09:49:35.740: Auto-RP(2): Build RP-Announce for 212.31.219.227, PIMv2/v1, ttl 5, ht 16
*Oct 4 09:49:35.740: Auto-RP(2): Build announce entry for (225.0.0.4/30)
*Oct 4 09:49:35.740: Auto-RP(2): Send RP-Announce packet on Serial0/0/0:0.301
*Oct 4 09:49:35.740: Auto-RP(2): Send RP-Announce packet on FastEthernet0/0.301
*Oct 4 09:49:35.740: Auto-RP: Send RP-Announce packet on Loopback11001
At PE ( near to receiver):
no ip pim vrf Multi_1 dm-fallback
At CE ( Receiver):
no ip pim vrf Multi_1 dm-fallback
ip pim vrf Multi_1 autorp listener
ip pim vrf Multi_1 spt-threshold 512 group-list SPT_groups
ip pim vrf Multi_1 accept-rp 212.31.219.227
ip pim vrf Multi_1 send-rp-discovery Loopback11001 scope 64
ip access-list extended Multi_1-SEC-LIST
Logs at Receiver CE:
.Oct 4 10:49:09.335 bst: Auto-RP(2): Build RP-Discovery packet
Please advice.
Thanks in advance.
Regds,
Ashutosh Pateriya
