cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
933
Views
0
Helpful
3
Replies

BGP Community output

Chetan Kumar Ress
Enthusiast
Enthusiast

Hi ,

Turing testing BGP community i found some different output.

I got link for SP & he was advertising community say 2000 & i would like to add more community as it reached to My AS.

So i would like to add two more community say 1000 & 1500 using additive  key word ( which will not overwite but will add it to existing string )

So when i added this community i got output as 1000 1500 2000 in sh ip bgp x.x.x.x .

So why this community is adding before SP community ?

i should see 2000 1000 1500 because the way of adding this community is  SP + 1000 + 1500 .

3 Replies 3

milan.kulik
Advocate
Advocate

Hi,

isn't the output just an ascending sequence?

As it should not matter in which order the communities were added, there is just a set of communities.

HTH,

Milan

Thanks For Reply

Actually i would like to know why it is showing me in ascending seq ?

Why it would not show me as i had appened the new community value ?

If i will config any seq with these community then also i get the same output.

Hi,

there is no order in community so it is just how the IOS is displaying it with lowest value first.

Regards.

Alain

Don't forget to rate helpful posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers