Cache Engine 510 - Replacing Hard drive

[jgiarret]

     I have a 510a Cache engine and the IDE hard drive failed.  I installed a new blank hard drive, but I can't get it to boot off of the new hard drive. Currently,  I moved the original to Disk 1.  I switched the boot up disk to disk 1.  I was then able to setup the new hard drive (in disk 0).  Everything is functioning, but I don't want to keep the dead hard drive in there.  How do I setup a boot sector on the new hard drive?

Thanks

[p.mcgowan]

you need to partition the new disk

"disk config sysfs 5% cfs 45% mediafs from-unused cdnfs remaining"

This should partiton the disk

[jgiarret]

I already partitioned the drive 10% sysfs and 90% cfs.. which is what we've been using for years.  It still doesn't boot off of the new drive.  thanks for the repsonce.

[p.mcgowan]

have you loaded the ACNS software onto the new disk?

once you have partitioned the disk you must load on the CE software you were previously running;

confgure CE gig 1/0 with an IP address

"copy ftp install <ftp server ip address>

"show hardware will show is software is installed correctly