Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our SIP provider has asked us to modify our outgoing SIP header INVITE messages to allow them to block CLI.The section of the current SIP Header we need to modify looks like this;Remote-Party-ID: "Test" <sip:+44xxxxxxxxxx@10.x.x.x>;party=calling;scre...
I'm trying to setup a backup location on UCCX version 7. The backup storage location and the UCCX server are seperated by a firewall.What ports are required to be opened on the firewall to allow the backups through to the backup location.Can't find a...
I'm accessing a CUCM via a terminal server which does not have RTMT installed and I don't have permissions to install it.Is there any way to view the number of devices registered with a server from the CLI??need to reboot all phones and want to make ...
I have discoverd a problem with the night-service date command on CME.I have 3 CME's configured with the following commands;telephony-servicenight-service date Aug 6 09:01 09:00!ephone-dn 31 no call-waiting beep generate number 121 no-reg primary la...
I have a CME with the following night service config;night-service date May 7 00:00 23:59night-service weekday 17:00 09:00Question I have is, at 00:00 on May 8, what happens?Does night-service weekday 17:00 09:00 command take over at 00:00?or will no...
backing up locally is not an optionthe backup must be completed on a remote server which sits on the opposite side to the firewall so we need the ports opened
Is the ACE the default gateway of the server or is the server using a different gateway? the return path from the server should also go via the ACE to keep the tcp connectionsplease rate helpful posts
If you need assistance with a design then the best place to go for advice is a Cisco partner rather than a support forum.trying to design something your not familiar with can lead to an expensive mistake
looks like you have a duplicate IP address on the networkshutdown interface vlan100 on switch A, this will make switch B the active switch, from switch B ping 10.8.51.253, if there is a duplicate IP you will get a response, this will then show in the...
the followng document details how replication works on a CUCM server and what write access a sub has in the event of a pub failure, it is an excellent document for explaining and troubleshooting replication issues on a CUCM clusterhttps://supportforu...
