can't get an IP @ from bridged dhcp

jackhunter · ‎08-13-2022

Hello I installed the CSR100v router in VMware workstation and I connect the first interface (g1) to the bridged of my WLAN network and when I configured this interface to get IP @ from DHCP it don't get i don't know why ???

MHM Cisco World · ‎08-13-2022

check the DHCP Server side your config for router is OK

paul driver · ‎08-13-2022

Hello
to the bridged of my WLAN network

how is that rtr connected is it within a vlan of an active dhcp scope

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

jackhunter · ‎08-22-2022

my VM router is not in vlan and my adsl router also

Karsten Iwen · ‎08-13-2022

Have you enabled promiscous mode on the vswitch?