05-02-2013 05:32 PM - edited 03-04-2019 07:48 PM
I have a 3560G that I cannot apply a policy route-map to one of the VLAN interfaces. I am running up to date software, c3560-ipservicesk9-mz.150-2.SE2 and it accepts the command, but does not show it in the sh run of the interface. I updated to this code as I had seen previously someone said it needed to be version 15 before you could apply route-maps to VLAN interfaces.
Any assistance would be greatly appreciated!!!
05-02-2013 06:43 PM
Hi Matt,
Check if below works...
show sdm prefer --> See if any memory allocated to PBR (there may be none).
Issue the command - sdm prefer route (write mem) and the reload the switch (make sure you have maintenance window, if this is production switch).
hth
MS
05-02-2013 07:46 PM
Thank you for the response, I have done this previously and it didnt help. That was what led me to believe upgrading the IOS might help.... The switch is in Desktop Routing mode and has memory allocated to PBR
05-02-2013 11:36 PM
Hi,
take a look here:http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/15.0_2_se/configuration/guide/swiprout.html#wp1228588 and here:http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/15.0_2_se/configuration/guide/swuncli.html#wpxref73623
Regards
Alain
Don't forget to rate helpful posts.
05-07-2013 07:37 AM
My switch is running IP services image and I have already run the sdm prefer routing command and reloaded. I ended up moving the machine to a different VLAN to force the routing.
Thanks anyways
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide