I have an R3925 with c3900-universalk9-mz.SPA.151-2.T3.bin with SEC loaded:
Technology Package License Information for Module:'c3900'
----------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
-----------------------------------------------------------------
ipbase ipbasek9 Permanent ipbasek9
security securityk9 Permanent securityk9
uc None None None
data None None None
The problem I am having is that I have enabled ipv6 unicast-routing, at the global level, and the interface level has ipv6 enable, yet I am unable to get a pd from the ISP as there is no option available for it in the interface:
r3925#conf t
Enter configuration commands, one per line. End with CNTL/Z.
r3925(config)#int g0/1
r3925(config-if)#ipv6 dhcp client ?
information Configure information refresh option
request Request
r3925(config-if)#ipv6 dhcp client
Other relevant configuration:
r3925#show run int g0/1
Building configuration...
Current configuration : 222 bytes
!
interface GigabitEthernet0/1
ip address 192.168.1.2 255.255.255.0
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
ipv6 address FE80::1 link-local
ipv6 address autoconfig default
ipv6 enable
end
r3925#show run | inc ipv6
ipv6 unicast-routing
ipv6 cef
ipv6 address FE80::1 link-local
ipv6 address autoconfig default
ipv6 enable
Any suggestions?