Cannot use Class map policy on atm interface

[cegomez75]

Cannot use Class map policy on atm interface ( Ocultar detalles )		Tarea personal	8/02/12
Notas: Dear friends can anyone help with this issue i´ve tried to configure class map policy on a atm interface, as follow: class-map match-all 256K-Monitoreo match access-group 101 ! ! policy-map Restricion class 256K-Monitor bandwidth 256000 And then on a subinterface: interface ATM0/1/0.1 point-to-point bandwidth 512 ip address 10.130.128.235 255.255.255.248 no ip proxy-arp ip accounting output-packets ip virtual-reassembly ip ospf network non-broadcast ip ospf mtu-ignore atm route-bridged ip bridge-group 1 pvc 0/46 protocol ip 10.130.128.234 broadcast encapsulation aal5snap service-policy output Restricion The problem is when i do a show running command the line service-policy output Restricion does not appear. When i introduce the command it doesn´t give any error. Hope some ideas to rosolve this Thanks Carlos

[Vivek Ganapathi]

Hello Carlos,

What is the model of cisco box you have? Also provide me the IOS version.

Thanks

Vivek

[cegomez75]

Hi Vivek!!

Here is the info you ask for:

Cisco 2811

System image file is "flash:c2800nm-advsecurityk9-mz.124-15.T10.bin

Thank you for your help

Carlos G.