Cant access 819 Router via CCP anymore

[sprocket10]

I have been setting up a 819HGW and seem to have locked myself out of the CCP interface. I can still access the unit via CCP Express and CLI but need to be able to access via the full CCP. I was finishing up the unit and configuring WAAS express and im not sure what change has affected this.

If I now try to access via CCP I get the below error. I have checked http and https via CLI.

"Security Applet failed on device 172.16.81.1 with error The HTTP and HTTPS protocols are not enabled on the router that you are attempting to discover. To discover the router, first use the Cisco IOS CLI to enable HTTP or HTTPS. Then discover the router."

[cadet alain]

Hi,

Can you provide the requested outputs.

Regards

Alain

Don't forget to rate helpful posts.

[sprocket10]

sorry, had to edit above, pasting error

[cadet alain]

Hi,

ok can you clear your access-list counters then do sh access-list 100 to get sure the counters are cleared then try to connect from inside with CCP and do a sh access-list 100 again to see the increasing counters.

Regards

Alain

Don't forget to rate helpful posts.