05-19-2010 07:00 AM - edited 03-04-2019 08:32 AM
Hi
Not much familiar with CATOS
what command allows to check interface details on CATOS, module #1 48 port 10/100/1000
I m interested in getting details for int giga 1/5
Solved! Go to Solution.
05-19-2010 07:19 AM
Hello Saquib,
sh port 1/5
additional counters are reported in
sh mac 1/5
example:
sh port 2/5
* = Configured MAC Address
Port Name Status Vlan Level Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
2/5 ptocern404pp1224 connected 605 normal a-full a-1Gb 10/100/1000
Port AuxiliaryVlan AuxVlan-Status
----- ------------- --------------
2/5 none none
Port Security Violation Shutdown-Time Age-Time Max-Addr Trap IfIndex
----- -------- --------- ------------- -------- -------- -------- -------
2/5 disabled shutdown 0 0 1 disabled 353
Port Num-Addr Secure-Src-Addr Age-Left Last-Src-Addr Shutdown/Time-Left
----- -------- ----------------- -------- ----------------- ------------------
2/5 0 - - - - -
Port Flooding on Address Limit
----- -------------------------
2/5 Enabled
Port Send FlowControl Receive FlowControl RxPause TxPause Unsupported
admin oper admin oper opcodes
----- -------- -------- --------- --------- ---------- ---------- -----------
2/5 on disagree desired off 0 0 0
Port Admin Channel LACP Port Ch Partner Oper Partner
key Mode Priority id Sys ID Port
------ ----- ------- --------- ---- -------------------------------- -------
2/5 718 passive 128 0 0:00-00-00-00-00-00 0
Port Status ErrDisable Reason Port ErrDisableTimeout Action on Timeout
---- ---------- ------------------- ---------------------- -----------------
2/5 connected - Enable No Change
Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
----- ---------- ---------- ---------- ---------- ---------
2/5 - 0 0 32127 0
Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts Giants
----- ---------- ---------- ---------- ---------- --------- --------- ---------
2/5 0 0 0 0 0 0 0
Last-Time-Cleared
--------------------------
Fri May 29 2009, 12:06:27
sh mac 2/5
Port Rcv-Unicast Rcv-Multicast Rcv-Broadcast
-------- -------------------- -------------------- --------------------
2/5 2701929405 0 2457154
Port Xmit-Unicast Xmit-Multicast Xmit-Broadcast
-------- -------------------- -------------------- --------------------
2/5 680508948 19331294 746433
Port Rcv-Octet Xmit-Octet
-------- -------------------- --------------------
2/5 3993868326093 103277529193
MAC Dely-Exced MTU-Exced In-Discard Lrn-Discrd In-Lost Out-Lost
-------- ---------- ---------- ---------- ---------- ---------- ----------
2/5 0 0 32127 0 0 0
Last-Time-Cleared
--------------------------
Fri May 29 2009, 12:06:27
Hope to help
Giuseppe
05-19-2010 07:07 AM
saquib.tandel wrote:
Hi
Not much familiar with CATOS
what command allows to check interface details on CATOS, module #1 48 port 10/100/1000
I m interested in getting details for int giga 1/5
From memory -
"sh port 1/5" should do it.
Jon
05-19-2010 07:08 AM
Use the "SHOW PORT" command for port details. The SHOW PORT COUNTERS is another good one. So for your example it will be "SHOW PORT 1/5".. Good Luck..
05-19-2010 07:19 AM
Hello Saquib,
sh port 1/5
additional counters are reported in
sh mac 1/5
example:
sh port 2/5
* = Configured MAC Address
Port Name Status Vlan Level Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
2/5 ptocern404pp1224 connected 605 normal a-full a-1Gb 10/100/1000
Port AuxiliaryVlan AuxVlan-Status
----- ------------- --------------
2/5 none none
Port Security Violation Shutdown-Time Age-Time Max-Addr Trap IfIndex
----- -------- --------- ------------- -------- -------- -------- -------
2/5 disabled shutdown 0 0 1 disabled 353
Port Num-Addr Secure-Src-Addr Age-Left Last-Src-Addr Shutdown/Time-Left
----- -------- ----------------- -------- ----------------- ------------------
2/5 0 - - - - -
Port Flooding on Address Limit
----- -------------------------
2/5 Enabled
Port Send FlowControl Receive FlowControl RxPause TxPause Unsupported
admin oper admin oper opcodes
----- -------- -------- --------- --------- ---------- ---------- -----------
2/5 on disagree desired off 0 0 0
Port Admin Channel LACP Port Ch Partner Oper Partner
key Mode Priority id Sys ID Port
------ ----- ------- --------- ---- -------------------------------- -------
2/5 718 passive 128 0 0:00-00-00-00-00-00 0
Port Status ErrDisable Reason Port ErrDisableTimeout Action on Timeout
---- ---------- ------------------- ---------------------- -----------------
2/5 connected - Enable No Change
Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
----- ---------- ---------- ---------- ---------- ---------
2/5 - 0 0 32127 0
Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts Giants
----- ---------- ---------- ---------- ---------- --------- --------- ---------
2/5 0 0 0 0 0 0 0
Last-Time-Cleared
--------------------------
Fri May 29 2009, 12:06:27
sh mac 2/5
Port Rcv-Unicast Rcv-Multicast Rcv-Broadcast
-------- -------------------- -------------------- --------------------
2/5 2701929405 0 2457154
Port Xmit-Unicast Xmit-Multicast Xmit-Broadcast
-------- -------------------- -------------------- --------------------
2/5 680508948 19331294 746433
Port Rcv-Octet Xmit-Octet
-------- -------------------- --------------------
2/5 3993868326093 103277529193
MAC Dely-Exced MTU-Exced In-Discard Lrn-Discrd In-Lost Out-Lost
-------- ---------- ---------- ---------- ---------- ---------- ----------
2/5 0 0 32127 0 0 0
Last-Time-Cleared
--------------------------
Fri May 29 2009, 12:06:27
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide