10-24-2012 10:38 AM - edited 03-04-2019 05:57 PM
I have route-map defined on my ASR 1002 12.2(33)XNE and applied to my gi0/0/1 interface. I need to change the IP address defined on the "set ip next-hop ..." line. My question is, when I make the change in just the route-map definition, does the change take effect immediately, or do I need to remove and re-apply the "ip policy route-map ..." statement on the interface? If I do have to remove and re-apply, will this be service-affecting for all the traffic flowing through the interface? I'm just not sure what to expect.
Thanks in advance.
John
Solved! Go to Solution.
10-24-2012 12:00 PM
Hello
this was discussed in the past for the 6500 platform, the same should apply to ASRs:
https://supportforums.cisco.com/thread/2004171
You don't need to remove and reapply.
Regards
Francesco
10-24-2012 12:00 PM
Hello
this was discussed in the past for the 6500 platform, the same should apply to ASRs:
https://supportforums.cisco.com/thread/2004171
You don't need to remove and reapply.
Regards
Francesco
10-24-2012 12:13 PM
Thanks Francesco. I know that some things are different on ASRs than other platforms (learned the hard way) so I wasn;t sure if this was one of those things.
Regards,
John
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: