cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
475
Views
0
Helpful
0
Replies

Changing packet destination based on source address/port? - PBR

ElishaDean5574
Level 1
Level 1

I'm looking to use PBR or Route Mapping to change the destination of a packet based on it's source IP and/or port. Both if it's possible, I'd like to specifically say "If the source is x.x.x.x coming over port x, change the destination to x.x.x.x and route it to tunnelx" regardless of the packet's original destination. I am using a CSR1000v on AWS to do this. If I could get a detailed description of how I can do this, or why I can't do this, I would much appreciate it!

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card