cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

112
Views
0
Helpful
1
Replies
Highlighted

Cisco 6254ME multiple reload

Hi,

I have a Cisco 6524ME with IOS Advanced IP services version 12.2(33)SXH4.

When the switch boots rightly, it reloads after 30 seconds that I can enter into CLI.

During this short time I execute "show diagnostic events" and the output is the following.

Diagnostic events (storage for 500 events, 1 events recorded)

Event Type (ET): I - Info, W - Warning, E - Error

Time Stamp         ET [Card] Event Message

------------------ -- ------ --------------------------------------------------

06/17 16:44:48.760 E  [1]    TestLoopback Failed

When I execute "show interface status", no output is reported.

Every 3 or 4 reloads the system remains in rommon mode at switch processor level.

Just previously entering in rommon mode, this message is reported:

*** System received a Software forced crash ***

signal= 0x17, code= 0x24, context= 0x430252b4

  PC = 0x411ac108, SP = 0x41bfc388, RA = 0x408d73b4

  Cause Reg = 0x00001020, Status Reg = 0x34008002

What is the problem?

Is there any solution?

Thanks in advance

Antonio

1 REPLY 1
Hall of Fame Community Legend

Cisco 6254ME multiple reload

TestLoopback Failed

RMA the appliance.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here