cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
881
Views
0
Helpful
1
Replies

Cisco 7206 IOS upgradation Issue

sanjeevmahadani
Level 1
Level 1

Guys,

Pls. suggest, unable to upload IOS for Cisco 7206 router, below is the error.

rommon 10 > boot system tftp c7200-is-mz.124-13d.bin 192.168.1.3

an alternate boot helper program is not specified

(monitor variable "BOOTLDR" is not set)

and unable to determine first file in bootflash

loadprog: error - on file open

boot: cannot load "system tftp c7200-is-mz.124-13d.bin 192.168.1.3"

Reg

sanjeev

1 Reply 1

Raju Sekharan
Cisco Employee
Cisco Employee

where is your image located?

if it is not present in the bootflash or compact flash of the router, you need to download this locally to bootflash or compact flash

1. You can check the availble devices in the router by using :dev command"

Example

rommon 1 > dev 
     Devices in device table:
             id  name 
     bootflash:  boot flash
         slot0:  PCMCIA slot 0 
         slot1:  PCMCIA slot 1
        eprom:  EPROM 
     rommon 2 > 
2. Then you can check if you have a vlaid image availbe in any of these devices

dir bootflash:
dir slot0:
dir slot1:

3. if you have the image preset in any of the devices, use that location to boot the image

ex:
rommon> boot bootflash:

4. if you don't have the valid image prestn in any of the devices, use tftpdnld process to download the image to any bootflash: or compact flash:

Here is the process

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bf9e.shtml

Then you boot the router using step 3

Review Cisco Networking for a $25 gift card