Hi all,
Been doing this most of the day, trying to configure cisco 800 series in bridge mode which is MPoA
Can anyone help, my config is
no ip routing
no ip cef
!
!
!
!
no ip domain lookup
ip domain name ****.***
!
!
!
username **** password 0 ****
!
!
!
bridge irb
!
!
!
interface ATM0
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
no ip route-cache
no snmp trap link-status
no atm ilmi-keepalive
dsl operating-mode adsl2+
bridge-group 1
bridge-group 1 spanning-disabled
!
interface ATM0.1 point-to-point
no ip redirects
no ip unreachables
no ip proxy-arp
ip virtual-reassembly
no ip route-cache
no snmp trap link-status
atm route-bridged ip
pvc 0/101
encapsulation aal5snap
!
bridge-group 1
bridge-group 1 spanning-disabled
!
interface FastEthernet0
shutdown
!
interface Vlan1
ip address *.*.*.* *.*.*.*
no ip route-cache
!
ip route 0.0.0.0 0.0.0.0 "ISP route IP" -< was told needed although was also told needed no ip routing