Cisco 831 router EIGRP

[rgrant22]

We were unable to do EIGRP on the Cisco 831 router. Do this router support EIRGP? If so, which code? I am using

c831-k9o3sy6-mz.124-1c.bin.

[stomasko]

Feature navigator doesn't show your particular version however 12.4(3c) does show eigrp support for the 831.

What happened when you tried to issue the command?

Hope this helps

Steve

[Harold Ritter]

This version that you are using should allow you to run eigrp as follow:

W228.08.07-800-2#sh ver

Cisco IOS Software, C831 Software (C831-K9O3SY6-M), Version 12.4(1c), RELEASE SOFTWARE (fc1)

W228.08.07-800-2#config t

Enter configuration commands, one per line. End with CNTL/Z.

W228.08.07-800-2(config)#router eigrp 1

W228.08.07-800-2(config-router)#end

W228.08.07-800-2#s

*Jul 13 06:55:29.613: %SYS-5-CONFIG_I: Configured from console by consoleh ip prot

Routing Protocol is "eigrp 1"

Outgoing update filter list for all interfaces is not set

Incoming update filter list for all interfaces is not set

Default networks flagged in outgoing updates

Default networks accepted from incoming updates

EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0

EIGRP maximum hopcount 100

EIGRP maximum metric variance 1

Redistributing: eigrp 1

EIGRP NSF-aware route hold timer is 240s

Automatic network summarization is in effect

Maximum path: 4

Routing for Networks:

Routing Information Sources:

Gateway Distance Last Update

Distance: internal 90 external 170

W228.08.07-800-2#

Hope this helps,