Hello,
My isp provides me with an adsl connection, details as below.
PPPoA
VCMUX
VPI 0
VCI 100
specific un/pass
I need to bridge my cisco867 such that the public ip is passed on to the device plugged into the lan port of the cisco867.
Can anyone provide me with a config to achieve this. By doing this I am totally under utilizing the cisco router but I have to do this, have no other choice.
I have checked other topics and the config does not seem to match or is not suitable for my requirements.
Here I want the cisco router to hold the PPPoA un/pass and authenticate.
My understanding of cisco devices is low to medium.
Any help will be much appreciated.
Regards,
Amit
this is what i use, if i was to NOT bridge the cisco router
*****************************************************************************
!
interface ATM0
no ip address
atm vc-per-vp 128
no atm ilmi-keepalive
pvc 0/100
encapsulation aal5mux ppp dialer
dialer pool-member 1
no shut
!
!
interface FastEthernet0
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
switchport access vlan 2
ip nat inside
no shutdown
!
interface Vlan1
ip address 192.168.1.1 255.255.255.0
ip access-group 100 in
ip inspect DEFAULT100 in
ip nat inside
ip virtual-reassembly
ip tcp adjust-mss 1380
hold-queue 100 out
!
!
interface vlan2
no shut
ip address 10.12.13.1 255.255.255.0
ip nat inside
!
interface Dialer0
no ip address
!
interface Dialer1
ip address negotiated
ip access-group 103 in
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap pap callin
ppp chap hostname user@isp.com
ppp chap password abcd123
ppp pap sent-username user@isp.com password abcd1234
hold-queue 224 in
!
********************************************************