Hi Guys,
i have a bit of an odd setup, which as been working fine until now, now cant figure out why it doesn't connect.
i have a bridge modem connected to FE1, then using vlan 100 to do the dialing, config and log below, any ideas why it now doesnt work? i think the modem could be faulty, although when you plug a laptop directly into it and create a PPPoE dialer it works fine.
interface FastEthernet1
switchport access vlan 100
no ip address
interface Vlan100
description SPARK INTERNET
no ip address
pppoe enable group global
pppoe-client dial-pool-number 1
interface Dialer0
ip address negotiated
ip access-group filter_incoming in
no ip redirects
no ip unreachables
no ip proxy-arp
ip mtu 1452
ip nat outside
ip virtual-reassembly in
encapsulation ppp
ip tcp adjust-mss 1412
dialer pool 1
ppp mtu adaptive
ppp authentication pap
ppp pap sent-username <Blank> password 0 <Blank>
Then i have turned on the following debugs
Generic ATM:
ATM events debugging is on
PPP:
PPP authentication debugging is on
PPP protocol errors debugging is on
PPP protocol negotiation debugging is on
PPPoE:
PPPoE protocol events debugging is on
PPPoE protocol errors debugging is on
VPN:
VPDN errors debugging is on
Logging:
Log Buffer (4096 bytes):
55: Vi2 LCP: Event[Receive ConfNak/Rej] State[ACKsent to ACKsent]
*Aug 25 01:55:06.559: Vi2 LCP: I CONFREJ [ACKsent] id 9 len 8
*Aug 25 01:55:06.559: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:06.559: Vi2 LCP: O CONFREQ [ACKsent] id 10 len 14
*Aug 25 01:55:06.559: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:06.559: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:06.559: Vi2 LCP: Event[Receive ConfNak/Rej] State[ACKsent to ACKsent]
*Aug 25 01:55:06.559: Vi2 PPP: Control packet rate limit 10 reached
*Aug 25 01:55:06.559: Vi2 PPP: Entering block state for 30 seconds
*Aug 25 01:55:06.559: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:09.351: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:12.651: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:15.951: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:18.751: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:21.863: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:24.751: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:27.551: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:28.711: Vi2 LCP: O CONFREQ [ACKsent] id 11 len 14
*Aug 25 01:55:28.711: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:28.711: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:28.711: Vi2 LCP: Event[Timeout+] State[ACKsent to ACKsent]
*Aug 25 01:55:28.715: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:30.727: Vi2 LCP: O CONFREQ [ACKsent] id 12 len 14
*Aug 25 01:55:28.711: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:28.711: Vi2 LCP: Event[Timeout+] State[ACKsent to ACKsent]
*Aug 25 01:55:28.715: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:30.727: Vi2 LCP: O CONFREQ [ACKsent] id 12 len 14
*Aug 25 01:55:30.727: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:30.727: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:30.727: Vi2 LCP: Event[Timeout+] State[ACKsent to ACKsent]
*Aug 25 01:55:30.727: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:30.751: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:32.743: Vi2 LCP: O CONFREQ [ACKsent] id 13 len 14
*Aug 25 01:55:32.743: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:32.743: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:32.743: Vi2 LCP: Event[Timeout+] State[ACKsent to ACKsent]
*Aug 25 01:55:32.743: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:33.751: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:34.759: Vi2 LCP: O CONFREQ [ACKsent] id 14 len 14
*Aug 25 01:55:34.759: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:34.759: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:34.759: Vi2 LCP: Event[Timeout+] State[ACKsent to ACKsent]
*Aug 25 01:55:34.759: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:36.451: Vi2 PPP: Packet throttled, Dropping packet
*Aug 25 01:55:36.787: Vi2 LCP: O CONFREQ [ACKsent] id 15 len 14
*Aug 25 01:55:36.787: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:36.787: Vi2 LCP: MagicNumber 0x0F4137ED (0x05060F4137ED)
*Aug 25 01:55:36.787: Vi2 LCP: Event[Timeout+] State[ACKsent to ACKsent]
*Aug 25 01:55:36.787: Vi2 LCP: I CONFREJ [ACKsent] id 15 len 8
*Aug 25 01:55:36.787: Vi2 LCP: AuthProto PAP (0x0304C023)
*Aug 25 01:55:36.787: Vi2 LCP: Received too many CONFREJs. Closing CP
*Aug 25 01:55:36.787: Vi2 PPP DISC: LCP failed to negotiate
*Aug 25 01:55:36.787: PPP: NET STOP send to AAA.
*Aug 25 01:55:36.787: Vi2 LCP: O TERMREQ [ACKsent] id 16 len 4
*Aug 25 01:55:36.787: Vi2 LCP: Event[CLOSE] State[ACKsent to Closing]
*Aug 25 01:55:36.791: Vi2 LCP: I TERMACK [Closing] id 16 len 4
*Aug 25 01:55:36.791: Vi2 LCP: Event[Receive TermAck] State[Closing to Closed]
*Aug 25 01:55:36.791: Vi2 LCP: Event[DOWN] State[Closed to Initial]
*Aug 25 01:55:36.791: Vi2 PPP: Phase is DOWN
*Aug 25 01:55:36.791: PPPoE : Shutting down client session
*Aug 25 01:55:36.791: [0]PPPoE 1: O PADT R:0ca4.02bc.4f16 L:f40f.1b43.ecf0 Vl100
*Aug 25 01:55:36.791: PPPoE: Failed to add PPPoE switching subblock
*Aug 25 01:55:36.791: %DIALER-6-UNBIND: Interface Vi2 unbound from profile Di0
*Aug 25 01:55:36.795: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to down
*Aug 25 01:55:36.795: PPPoE: Unexpected Event!. PPPoE switching Subblockdestroy called
