04-14-2010 09:22 AM - edited 03-04-2019 08:09 AM
Hello Community
I have to solve the task manager put in front of me: make Cisco 888 and ZyXel P-783H G.SHDSL routers cooperate to provide 4 wire access to ISP.
I able to get DSL link up using SANP encapsulation (LLC on ZyXEL side), however Cisco TX counters reports 0 .RX increasing constantly.
This is the part of atm configuration:
!
interface ATM0
no ip address
no atm ilmi-keepalive
pvc 0/33
protocol ip 87.252.254.149 broadcast
encapsulation aal5mux ip
!
bridge-group 1
end
ZyXel is set as Bride using RFC 1483 encapsulation and LLC multiplexing.
I've tried troubleshooting technic described into " IP over ATM " section of support site.
If I set the LLC encapsulation I"ve got only singe error message stating encapsulation error : "Send:Error in encapsulation, No VC for address 0x00"
if I set encapsulation to VC (on ZyXel and aal5muc on cisco 888) debugging output produce constant encapsulation error messages " 0: ATM(ATM0) Send:Error in encapsulation, No VC for address 0x0"
And again, TX counter doesn't increase.
From this I conclude that such configuration is not viable: however I would like to ask community if someone faced similar problems. Any help would be highly appreciated. Many thanks in advance...
04-27-2010 11:36 PM
Ok, I will have to answer myself, since I solved the problem:
First I have to admit, that this configuration is fully viable, and my problem were related only to luck of knowledge.
ZyXEL Configuration:
WAN interface: Bridge mode, Encapsulation RFC 1483, multiplexing LLC, service type- server,service mode 4-wire, standard mode - annex b, no reate adoption, max -rate -match the Cisco settings. Additional setting - allow PPPoE and everything else, that might prevent the traffic to go through the ZyXEL, firewall, NAT and so on...
And Cisco 888:
controller DSL 0
mode atm
line-term cpe
line-mode 4-wire enhanced
dsl-mode shdsl symmetric annex B
ignore-error-duration 15
line-rate 4480
interface ATM0
mtu 1500
ip address x.x.x.x x.x.x.x
no atm ilmi-keepalive
pvc 3/36
inarp 1
no oam-pvc manage
encapsulation aal5snap
pppoe max-sessions 10
pppoe-client dial-pool-number 1
Last 2 lines are related to provider's authorisation. We use PPPoE, but might be set PPP or PPPoEoverATM as well.
Diler interfaece accordingly.
Cheers...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide