cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
975
Views
0
Helpful
1
Replies
Highlighted
Beginner

Cisco 891F

hi,

I am looking at an 891F for dual wan and vpn to aws

have a secondary (tentative) requirement to terminate several vpns on this device to both wan ports but also were hoping to terminate vpns on other public ips on the router. im using vrf for this with loopback interfaces. however tunnel does not come  up -

getting   Tunnel linestate evaluation down - linestate protection reg down and crypto isakmp in mm_no_state.

any ideas
 

Hardware is Tunnel
  Internet address is 169.x.x.x/30
  MTU 17940 bytes, BW 100 Kbit/sec, DLY 50000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation TUNNEL, loopback not set
  Keepalive not set
  Tunnel linestate evaluation down - linestate protection reg down
  Tunnel source 19.x.x.x (Loopback200), destination 52.x.x.x
   Tunnel Subblocks:
      src-track:
         Tunnel200 source tracking subblock associated with Loopback200
          Set of tunnels with source Loopback200, 1 member (includes iterators), on interface <OK>
  Tunnel protocol/transport IPSEC/IP

1 REPLY 1
Highlighted
Beginner

Did you ever find a resolution for this issue?

Content for Community-Ad