hi,
I am looking at an 891F for dual wan and vpn to aws
have a secondary (tentative) requirement to terminate several vpns on this device to both wan ports but also were hoping to terminate vpns on other public ips on the router. im using vrf for this with loopback interfaces. however tunnel does not come up -
getting Tunnel linestate evaluation down - linestate protection reg down and crypto isakmp in mm_no_state.
any ideas
Hardware is Tunnel
Internet address is 169.x.x.x/30
MTU 17940 bytes, BW 100 Kbit/sec, DLY 50000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation TUNNEL, loopback not set
Keepalive not set
Tunnel linestate evaluation down - linestate protection reg down
Tunnel source 19.x.x.x (Loopback200), destination 52.x.x.x
Tunnel Subblocks:
src-track:
Tunnel200 source tracking subblock associated with Loopback200
Set of tunnels with source Loopback200, 1 member (includes iterators), on interface <OK>
Tunnel protocol/transport IPSEC/IP
