cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
801
Views
0
Helpful
5
Replies
Highlighted
Beginner

Cisco Catalyst 4510 R-E Password recovery

Hi

 

I have a Cisco Catalyst 4510 R-E that requires a password recovery how do I go about removing the password

 

I have the following cards installed

 

2 x WS-X45-SUP6-E  Supervisor engine 6-E

1x WS-X4624-SFP-E

1x WS-X4648-RJ45V-E

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Kindly refer this link, http:

Kindly refer this link,

 

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-4000-series-switches/21229-pswdrec-cat4000-supiii-21229.html

View solution in original post

5 REPLIES 5
Highlighted
Beginner

Kindly refer this link, http:

Kindly refer this link,

 

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-4000-series-switches/21229-pswdrec-cat4000-supiii-21229.html

View solution in original post

Highlighted
Beginner

HiFollowed the information

Hi

Followed the information given on the above link, I'm still getting not able to access the switch I'm still prompted for the password under the companies banner, I have the two supervisor engines attached to  the unit and my cisco console cable is connected to the top one,

 

Thanks

 

Paul

Highlighted
Beginner

I've resolved the issue by

I've resolved the issue by removing the redundant supervisory engine then erasing the main supervisory engine and vice versa. unit is now factory default.

 

Thanks

 

Highlighted
Beginner

Great I appreciate your

Great I appreciate your effort !!!

Highlighted
Beginner

Re: Kindly refer this link, http:

The procedure here doesn't work for the supervisor engine WS-X45-Sup6-E because the confreg 0x2142 command isn't recognized, for me anyway. I will try what Paul tried here and see if that works.