Routing

I am currently a 4th-year student in PTIT, majoring in telecommunications network Currently I am preparing to do the project but still do not know the direction of how Hope people can give some ideas for your projectCurrently, I am preparing to do th...

An IPv6 tunnel (Hurricane Electric) has been in place and working for years. US resident endpoint devices looking to connect to NETFLIX are routed to the IPv6 address where NETFLIX denies access to content since NETFLIX cannot determine if the endpoi...

I've set up multiple routers over the years by a handful of companies. If there was ever a problem, typically there was always as solution to be found on the internet. Never have I had so much trouble with a router that I've been forced to register o...

Hi, i have open some ports on the router before and without problems, but when im doing it now, the setting is not showing upp in show conf, im typing this command: ip nat inside source static tcp 10.0.0.8 7563 interface cell0 7563     Here is my con...

Hi, I have 2 subnetworks and I want to seperate them so that they cannot communicate with each other. Below is how I have tried to do it but, it doesn't work as when I attempt to ping from one to another it still goes through. Am I missing something?...

I have an urgent problem with the Cisco aironet AIR-AP1852I-E-K9C the problem is:   The access point has two SSIDs   1- SSID for Employee 2- SSID for Guest   The firste SSID works without any problems But the second one works only with mobile phones ...

Hello Gents, Would like to have your support to understand the following content of a MAC ADD Table for SW1. I have 3 switches interconnected with trunk links : SW3 (with a native Vlan 99, ip 192.68.1.3) - SW2 (with a native Vlan 99, ip 192.68.1.2) -...

PLease explain below command "ip rsvp bandwidth 140000 sub-pool 46000"   Once the TE tunnel is UP will 46MB be reserved explicitly for single tunnel or this is max it can reserve for itself.   i.e If the tunnel is not using 46MB for itself can non-tu...

We have some disagreement on what is the best practice for setting up the management port on a cisco router.  Some people say connect it directly to the internal network, bypassing all firewalls.  Some say this could be a vulnerability in case the ro...

Hi ,  May I ask a question , How many GRE Tunnels does it support on Cisco Catalyst6807 switch with SUP6T  Engine ? I cannot search the information on website .    Thanks for your kindly help .   Best Regards , Peter Yang   

Hi, I have a 3850 with a static default route to the ISP.  This 3850 has a eBGP neighbour with a downstream FTD 2110. The ISP and firewall are in the same IP range for the outside interface but I can't have a static route on the firewall because of a...