cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
784
Views
0
Helpful
2
Replies

Cisco ISR C1117

digi076
Level 1
Level 1

Hey guys,

 

We have a test lab in our office where we used to work with a Cisco 887va on a VDSL circuit.

Now we have a new setup with a Cisco ISRC1117-4PLTEEA on the same circuit. 

The latter is using IOS-XE.

 

Everything works fine except for the voip phones. They cannot provision anymore. Showing "no service" on the display. They do receive a IP-address via DHCP. They connect to a Asterisk based PBX external. 

 

So basicly the config is the same like it was on the 887va, but I have no idea why the phones are not registering anymore. 

 

Anyone in the same boat on this? Suggestions much appreciated :)

Thank you. 

2 Replies 2

johnd2310
Level 8
Level 8

Hi,

Are you using firewall on the router? is there any port forwarding and is it same as 887?

 

Thanks

John

**Please rate posts you find helpful**

hi John,

 

no the ZBF is not enabled, just ACLs which are the same as the 887 router. 

There are no port forwardings..

Review Cisco Networking for a $25 gift card