02-22-2021 02:49 AM
Hi team,
Our customer had a Cisco 3945 with VWIC2-2MFT-G703, now, they have changed it for a Cisco ISR443 with NIM-8CE1T1-PRI and tells us that now the 2Mb link doesn't work for them.
I have searched for documentation to configure the NIM-8CE1T1-PRI card in E1 G.703 unstructured mode, but have not found any information.
I have only found a document that talks about this configuration but for VWIC cards "E1 G.703 Unstructured Configuration", my question is, the configuration is the same for VWIC cards and NIM cards?
Can you provide me with some configuration example?
Thanks & Best Regards,
JuanMi
Solved! Go to Solution.
02-23-2021 02:22 AM
Hi Giuseppe,
We have already solved the problem, our customer has the clock synchronization incorrectly configured.
Thanks & Best Regards,
JuanMi
02-22-2021 03:47 AM
Hello @jmhalegre ,
if the command
channel-group 0 unframed
is not supported under the controller e1 configuration.
the feature is likely unsupported on the NIM on the new router.
Hope to help
Giuseppe
02-22-2021 04:03 AM
02-22-2021 05:03 AM
Hello @jmhalegre ,
what is the state of interfaces:
multilink1
multillink2
and of each member serial link ?
If you see LCP open up/up you should be fine otherwise if they are up/down or down/down there is an issue.
you can troubleshoot with
debug ppp negotiation
Hope to help
Giuseppe
02-22-2021 05:13 AM
Hi Giuseppe,
Thanks for the info, tomorrow I have a meeting with our customer to do some checks, I'll keep you informed with the result.
Best Regards,
JuanMi
02-23-2021 02:22 AM
Hi Giuseppe,
We have already solved the problem, our customer has the clock synchronization incorrectly configured.
Thanks & Best Regards,
JuanMi
02-23-2021 02:37 AM
Hello @jmhalegre ,
you have been kind to provide feedback on this issue.
Clock problems are among the most common on this type of WAN technology
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide