04-24-2008 08:51 AM - edited 03-03-2019 09:41 PM
I am trying to setup 2 routers Lab.
Routers: 2501 and 2524.
Q. How do I connect these two routers by
cables. I have one transcevier only.
one rollover R45 cable. I have
configure both the routers. But don't
know how to connect these and make CNA lab.
04-24-2008 12:46 PM
Hello,
You have two options:
1- The easiest is to get serial Cables and connect the routers back to back. You will need to set the clock on the DCE side of the cable. You will need one V.35 Serial Male Cable and another V.35 Female cable.
2- Terminate the two routers serially to two NTUs and connect the NTUs using RJ-45 cable to each others thus simulating a leased line betyween the router. Therefore, you need to NTUs with two serial cables.
Hope this helps and appreciate your rating,
Regards,
04-24-2008 12:55 PM
Thanks
04-24-2008 12:47 PM
hi, do not waste your time with that.
use this: http://www.dynagen.org/tutorial.htm
or even better GNS3
serg
04-24-2008 02:02 PM
Yes I am doing Dynamips also. Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide