02-10-2010 08:35 PM - edited 03-04-2019 07:28 AM
Dear All,
I want to ask you that i have cisco Router 1841 but on port F0/0 and port F0/1 not have power when i plug cable to this port.
this is message that i got :
Router(config)#do sh ip int br
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 192.168.1.1 YES NVRAM up down
FastEthernet0/1 192.168.2.1 YES NVRAM up up
Router(config)#
*Feb 11 04:23:48.955: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State changed to: Initialized
*Feb 11 04:23:48.959: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State changed to: Enabled Phy reset failed
Router(config-if)#Phy reset failed
what is going on ?
Best Regards,
Norung
Solved! Go to Solution.
02-10-2010 08:38 PM
02-10-2010 08:38 PM
Hi Norung,
What do you mean "power"? Both ports are not PoE.
02-10-2010 08:49 PM
Dear leolaohoo,
I mean that when we plug cable to Router then we see light on on port ( link,100 and FDX) but my problem is when i connect it i dont see the light.
Sorry i wrong to cleck correct answer.....
02-10-2010 08:56 PM
FastEthernet0/1 is OK but FastEthernet0/0 isn't. Can you post the config?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide