Cisco1841 Routers

jolaoba · ‎10-09-2023

I uploaded

adventerprisek9

to my 1841 router however my router failed to boot the program so it stuck on rommon mode, what can I do gain access upload a new program?

M02@rt37 · ‎10-09-2023

Do you have an error during boot process?

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

jolaoba · ‎10-10-2023

Yes I do - its says boot cannot load flash read only mode initialised

Leo Laohoo · ‎10-09-2023

Console into the router and reboot.

Post the entire boot-up process.

jolaoba · ‎10-10-2023

M02@rt37 · ‎10-10-2023

Please check of flash card is inserted:

After that do >dir flash:

And share output here please.

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.