Class based Qos monitoring on cisco 6509

[gilou_1973]

hello,

I set globally the QOS on my infrastructure and I want to monitor graphically the usage of each classes.

I'd like to do that on my COREs Switchs which are Catalyst C6509.

I can achieve that in command line, but it's not user friendly and it's not possible to have daily/hourly graphs.

So the idea is to find the value in the MIBS and put it in MRTG graphs.

The only problem is that I cannot find it in the MIBS.

Is someone has an idea?

Kind regards

Gildas

[Atif Awan]

6500 supports the CISCO-CLASS-BASED-QOS-MIB. I think you should take a look at polling it to get the required information. Additional MIB information is at:

http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&mibName=CISCO-CLASS-BASED-QOS-MIB

Atif

[gilou_1973]

Thanks Atif for the information, but have you got any idea about the OID, because in the MIBs it's hard to find the good entries.

Regards

GIldas