Communication problem on routers with Access Lists

[Timothysaunders]

I tried to use access lists on router. They can contact each other but when I use access lists on Router1. I created an named and extend access list which name was list1. It prevents FTP from 192.168.5.0 to 192.168.1.200. When I use that access list on Router1 I cannot ping computers. Any help?   ManageMyHealth Portal

[Georg Pauwen]

Hello,

what is the context of your question ? Is that a Packet Tracer project ? If so, post the zipped Packet Tracer project (.pkt) file. Otherwise, post at a minimum the full running configurations (sh run) of all routers involved, and indicate how they are connected (either put descriptions on the interfaces, or provide a drawing of your topology).

[MHM Cisco World]

you must end your acl with permit any any, because the ACL is by default end with deny any any.
that why ping failed 

[paul driver]

Hello
Not enough information, Can you elaborate on your existing network setup , post the running configuration of the rtr (inc access-list)  you have applied