This is for Class
This is for Cisco CCNA 2
When configing Router with 2 subnet's lans' and wan
using pat or nat
do you
config two port on the router for lan
address that are privent that are part of the subnet
and
config one port on the router for wan
inside ip that is privent that are part of the subnet
set the wan inside ip to go to the internet
outside ip that is from the ISP
set rip 2
0.0.0.0 0 .0.0.0.0 to the inside ip that is privent on the wan
or
config two port on the router for lan
address that are privent that are part of the subnet
set the interface to inside
set the ip on the lan that can go to through the wan
and
config one port on the router for wan
outside ip that is from the ISP
set rip 2
0.0.0.0 0 .0.0.0.0 (to the wan"expole s0/.0/0 or fa0/0")
thank for the help
==============================
or
==============================
can any one exsplane configing net or pat
