cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7291
Views
5
Helpful
4
Replies

Configuration not saving in 1841

majed.balsharaf
Level 1
Level 1

Hi

I'm having 1841 Router, its configuration is not getting safed. If I reboot the router all my running-config is like default. But when I check my

sh startup all the configuration which I did is displayed.   Checked the config-registery too and its 0x2142 changed too 0x2102 still the same problem, when reloading the router all the running config is disappeared.

4 Replies 4

Raju Sekharan
Cisco Employee
Cisco Employee

Check if you are able to open the startup-config from the nvram

commad: more nvram:startup-config

Sandeep Choudhary
VIP Alumni
VIP Alumni

HI Majed,

You need to change the config register.

The routers were left in password recovery  mode of 0x2142.  Changing it to the proper 0x2102 fixed this mess.  I  hope this will save others who come across this problem.

Do this: en conf t config-register 0x2102

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml

Hope it helps.

Regards

please rate if it helps.

Thanks for solution

Hello

post the output to

 

show boot 

 

res

paul


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Review Cisco Networking for a $25 gift card