Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am having Cisco 2911/K9 router. And I want to connect my both WAN links on it with redundancy. Both WAN links are using BGP protocol with different AS number.Primary WAN LinkBGP 100Connected on g0/1 ( of router) ------------------------------...
Hi I am having two circuits of BGP with same AS 65xx5. Can i connect them in one router and split the traffic,as i needmy LAN 1 to go via WAN 1 my LAN 2 to go via WAN 2As I am having configuration for both WAN'sFor WAN 1router bgp 65xx5nei 17
Hi, I need to know which IOS should I download for my 2811 router to get all ip sla featuresRouter(config)# ip sla ?<1-2147483> Entry Numberautoenable...........Note this is from my 2951 router.I need full features like this in my 2811 router.so ...
Hi I need to use:track 1 ip sla 1 reachabilityIn my 4507R core switch.Need to know which IOS should I use for this command as now I am using cat4500-entservices-mz.122-46.SG.binIn this when I am using (config)#track 1 ip ? route IP route(no optio...
Hi I am having wireless (2504) controller with 10(AIR-AP114) AP connected to it. And they are connected in my network to internet.I want to give different SSID with different level of security.Example:SSID 1 : Guest (access level limited)SSID 2 :...
Yes I have both ISP's running. How I should configure to make it fail over. Examplerouter bgp 100neighbor 62.149.x.x remote-as 65000redistribute connected router bgp 200neighbor 192.168.100.x remote-as 29684 How I can make failover
Dear Vasilii, Thanks for your reply. I am having two provider for our IPVPN network running on BGP. I need the backup link to be active if Primary link goes down.But the problem is I am having only one router. I am attaching image file for the d...
Thanks I am near to my answerBut I have to interface WAN IP's for LAN 1 WAN ip is 10.21.x.224/30For LAN 2 WAN ip is 171.31.x.220/30With Same bgpif I assign the interface with this IP's ok. but when I go in router bgp 65xx5 what neighbour shall i cho...
Thanks I am near to my answerBut I have to interface WAN IP's for LAN 1 WAN ip is 10.21.x.224/30For LAN 2 WAN ip is 171.31.x.220/30With Same bgpif I assign the interface with this IP's ok. but when I go in router bgp 65xx5 what neighbour shall i cho...
