Configuration not saving in 1841

[majed.balsharaf]

Hi

I'm having 1841 Router, its configuration is not getting safed. If I reboot the router all my running-config is like default. But when I check my

sh startup all the configuration which I did is displayed.   Checked the config-registery too and its 0x2142 changed too 0x2102 still the same problem, when reloading the router all the running config is disappeared.

[Raju Sekharan]

Check if you are able to open the startup-config from the nvram

commad: more nvram:startup-config

[Sandeep Choudhary]

HI Majed,

You need to change the config register.

The routers were left in password recovery  mode of 0x2142.  Changing it to the proper 0x2102 fixed this mess.  I  hope this will save others who come across this problem.

Do this: en conf t config-register 0x2102

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml

Hope it helps.

Regards

please rate if it helps.

[rsaxena]

Thanks for solution

[paul driver]

Hello

post the output to

show boot 

res

paul