We are doing hardware refresh for our offices in australia and having issue with bringing up the circuit on the new router.
The old router are all 2621 with WIC-1T and external CSU/DSU. The new router are all 2911 with HWIC-2CE1T1-PRI card.
Please see below for configuration pertaining to the E1 Controller
card type e1 0 0
network-clock-participate wic 0
controller E1 0/0/0
framing NO-CRC4
channel-group 0 timeslots 31
interface Serial0/0/0:0
bandwidth 1984
no ip address
ip flow ingress
encapsulation frame-relay IETF
service-policy output mpls_australia
!
interface Serial0/0/0:0.1 point-to-point
bandwidth 1984
ip address x.x.x.x 255.255.255.252
ip flow ingress
frame-relay interface-dlci 401 IETF
Here's the circuit information we received from Verizon:
CCS,31 CHANNEL E-1
CRC4-OFF,FRAMING FOR E-1
HDB3,HIGH DENSITY BIPOLAR 3
INTL,INTERNATIONAL
During the cutover, I can see the serial interface is up but line protocol is down, and pvc stayed in deleted state.
Does anyone see anything missing from the controller configurations based on the information that verizon had provided to us ?
Thanks
Irman