On a 2911 with a VWIC3-1MFT-T1/E1, is there a special configuration that I need to do to make it data-only? We don't need voice yet, and all the configurations that I've seen as I read through hundreds of posts talk about configuring the card for voice, and so far zilch for data-only. My configuration is as follows:
!
card type t1 0 0
!
...
!
controller T1 0/0/0
cablelength long 0db
channel-group 0 timeslots 1-24
!
...
!
interface Serial0/0/0:0
description T1 to ISP
ip address 192.168.0.2 255.255.255.252
!
As you can see, I used configuration examples I found on the Internet, which I found to be the right way to configure the VWIC3 according to the Cisco manual. This must be the bare minimum configuration to get it working. However, I feel that this configuration is for voice, and may hinder data traffic. If someone can point me in the right direction, that would be great.
Many thanks!
Arnel
